Home > Hp Psc > Hp Psc 1510 Error Code

Hp Psc 1510 Error Code

Contents

Gezinmeyi atla TRYükleOturum açAra Yükleniyor... If these steps resolved the issue, you do not need to continue troubleshooting. Disconnect the power cord from the rear of the product. The carriage moves into the access area on the right. check over here

Figure : Print Cartridge and both Start Copy lights blinking Figure : Print Cartridge and Black Start Copy lights blinking Figure : Print Cartridge and Color Start Copy lights blinking Solution note: This video shows the HP Deskjet 1510 e-All-in-One printer, but the steps are the same for your printer. If you have trouble viewing the video or to view the Open the cartridge access door. If the printer is off, press the Power button to turn on the printer. get redirected here

Hp Psc 1510 Troubleshooting Flashing Lights

The tri-color cartridge () goes in the slot on the left. Philippe041 111.065 görüntüleme 9:40 Preventive Maintenance HP PSC 1510 Part 1 - Süre: 4:36. An obstruction is blocking the paper path. Reconnect the power cord to the rear of the product.

Solution four: Resolve a scanning error Follow these steps to resolve a scanning error. Step one: Change the settings Select one of the following methods to change the paper size setting to match the print job. If you see a message saying that you have an incorrect ink cartridge, a flashing cartridge light meaning a bad color cartridge or you are told to remove the color cartridge, Hp Deskjet 1510 Ink Cartridge Problem Click System Preferences.

Figure : Lower the output tray Pull out the tray extender. Hp Deskjet 1510 Lights Flashing note: This video shows the HP Deskjet 1510 e-All-in-One printer, but the steps are the same for your printer. If you have trouble viewing the video or to view the Figure : Close the cartridge access door Press the Power button () to turn on the product. their explanation Step two: Print a self-test report Press and hold the Cancel/Resume button (), and then press the Start Copy Color () button.

Touching these parts can result in clogs, ink failure, and bad electrical connections. Hp Psc 1510 Check Print Cartridge Error If the product finishes the task, there is no need to continue troubleshooting. Yükleniyor... If necessary, click your model in a list of similar printers.

Hp Deskjet 1510 Lights Flashing

Figure : Open the cartridge access door caution: Wait until the carriage is idle and silent before continuing. Plug the power cord directly into an electrical outlet. Hp Psc 1510 Troubleshooting Flashing Lights From the Size: drop-down list, click More to access the paper size options. How To Reset Hp 1510 Printer Click Start, and then click My Computer.

While holding down the Power button, press and hold the Cancel button. check my blog caution: Before turning the printer, use your hand to secure the scanner lid. If the issue persists, see the next step. Remove any loose paper or obstructions you find. Hp Printer All Lights Flashing

  • Figure : Open the cartridge access door With the product turned on, disconnect the power cord from the rear of the product.
  • Solution seven: Replace the cartridge Follow these steps to replace the cartridge or cartridges indicated by the blinking light.
  • Clean only the copper-colored contacts, and then allow the cartridge to dry for approximately 10 minutes.
  • Use the swab to clean the electrical contacts in the carriage, located inside the printer on the carriage slots.
  • If these steps resolved the issue, you do not need to continue troubleshooting.
  • Bu videoyu bir oynatma listesine eklemek için oturum açın.
  • Press the Power button () to turn off the product.
  • Figure : Lower the output tray Pull out the tray extender.
  • Release both buttons at the same time.
  • Figure : Insert the paper into the paper tray Slide the paper width guide inward until it is snug (but not tight) against the paper.

The Estimated Ink Levels window opens. Wait until the carriage is idle and silent before continuing. If the product does not turn on by itself, press the Power button () to turn it on. this content Step six: Clear any jammed paper from underneath the printer Disconnect the USB cable from the rear of the printer.

Save the new scan as the desired file type. Hp Printer Blinking Orange Light Check the rear of the printer to make sure that the cord from the power supply is inserted securely into the power connection. Wait about 30 seconds for the alignment page to automatically print.

Press the Power button () to turn on the product.

Make sure that the icon on the cartridge matches the icon on the slot. Reklam Otomatik oynat Otomatik oynatma etkinleştirildiğinde, önerilen bir video otomatik olarak oynatılır. If the product never finishes the task, and the lights continue to blink, continue to the next solution. Hp Photosmart C3180 Check Print Cartridge Light Flashing Figure : Close the cartridge access door Step six: Align the cartridges After the product prints a cartridge alignment sheet, follow these steps to align the cartridges.

caution: To avoid a paper jam when using legal-size paper, do not open the paper tray extender. Cartridges marked with a square or pentagon, go into the right carriage slot. Hold them both down for 2 or 3 seconds. http://batteryuniveristy.com/hp-psc/hp-psc-750xi-error-code.php Press the Power button to turn on the printer.

In my personal opinion they are probably the highest quality printers HP has ever built. Torn, wrinkled, or damp paper loaded in the paper tray. note: If Save is unavailable, make sure that there is a name for the setting in the Name box. note: You must type a custom size name in the Name box.

If this happens, press and quickly release the Power button again. note: The name of the button or window depends on the software you are using. If the printer is off, press the Power button to turn on the printer. Step nine: Print a test page Print a test page to make sure that the hardware functions correctly.

Turn on the printer.Step 4Print a test page. Follow these steps to remove, and then reinsert the cartridges. Check the control panel to see if the lights are still blinking. Solutions Solution one: Wait for the product to finish the task If the product is busy, wait for the product to finish the task.

© Copyright 2017 batteryuniveristy.com. All rights reserved.