Home > Hp Psc > Hp Psc 1350 Install Fails

Hp Psc 1350 Install Fails

Contents

Printer State said that Linux was uanble to locate printer "cups-server". Reconnect the USB cable to the rear of the product. Apply a moderate amount of pressure to remove any dust or dirt buildup. Press the On/Resume button () to turn on the product. check over here

Thus, Vista recognizes the printer. >> >> I can scan a document using any (?) >> graphics software.. >> >> But in the course of install the software fails to detect Thanks to my sister's campus internet connecting to the internet is pretty complicated - i.e. Torn, wrinkled, or damp paper loaded in the paper tray. Disconnect the USB cable from the rear of the product.

Hp 1350 Printer Check Print Cartridge Error

What makes you say that? Solution three: Perform a partial reset A partial reset returns the user settings to their factory defaults. If the issue persists, continue to the next solution. http://h10025.www1.hp.com/ewfrf/wc/s...306888&lang=en -- Cari (MS-MVP) Windows Technologies - Printing & Imaging http://www.coribright.com/windows "FG" wrote in message news:%[email protected] >I must add that I used the software for Vista from HP website. >

Reconnect the power cord to the rear of the product. Last edited by notKlaatu; 03-02-2014 at 04:36 PM. Make sure that the length and width adjusters on the tray are correctly positioned, and then push the stack of paper forward until it stops in the tray. Hp Psc 1350 Manual Solution three: Match the paper to the paper settings Follow these steps to make sure that the paper loaded into the product matches the paper size and type settings in the

note: The black cartridge belongs in the slot on the right. Hp Psc 1210 Check Print Cartridge Error I followed HP's advice at this point, unplugged it and replugged it and after two replugs it came back to that same error message where I directed it to the newly The reset is now complete. http://h30434.www3.hp.com/t5/Inkjet-Printing/Error-message-for-printer-PSC-1350-with-Mac-10-6-8/td-p/955983 Figure : Reinsert the cartridge Firmly push the cartridge in until it snaps into place.

I believe I have a AMD Radeon HD 7570 I don't know... How To Reset Hp Psc 1410 Printer If the product does not complete the cartridge alignment, it will print an alignment page every time you turn on the product. All this works flawlessly under >> WinXP. >> >> Thanks. >> >> > > Cari \(MS-MVP\) LinkBack Thread Tools Display Modes « Previous Thread | Next Thread » Thread Remove any loose paper Do not pull jammed paper Step two: Clear the paper jam from the rear of the All-in-One caution: Never pull jammed paper from the front of the

Hp Psc 1210 Check Print Cartridge Error

The following recommendations can help prevent recurring paper jams in your HP product. http://www.sevenforums.com/drivers/59653-hp-driver-error.html Well, this did change things quite a bit. Hp 1350 Printer Check Print Cartridge Error Figure : Snap the cartridge into place Repeat these steps to clean the contacts on the other cartridge and in the other side of the carriage. Hp Psc 1210 Troubleshooting I had to install an HP 1215 using the driver CD that came with the new 1402 printer Followed the advice from HP, except this time I searched for the USBPRINT.IN_

Showing results for  Search instead for  Do you mean  or Post new question Post new question Question Reply Topic Options Subscribe Mark Topic as New Mark Topic as Read Float this check my blog If the product does not turn on, continue to the next solution. Press and release the Copies button. Issue: The Check Paper light blinks In this error condition, the following blinking lights pattern displays on the control panel: On/Resume light: On Check Paper light: Blinking Check Print Cartridge light: Hp Psc 1315 Check Printer Cartridge Error

  • Check to see if the power module has an LED.
  • In short, it just sits idly there, ignoring the input from the driver.
  • Open the cartridge access door.
  • Do not overload the tray with paper.
  • Try the intended task again.
  • If you cannot cancel the task, press and hold the On/Resume button () for three seconds to turn off the product.

please suggest me My System Specs OS windows 7 ultimate 32bit jakhsnil View Public Profile Find More Posts by jakhsnil 14 Jun 2012 #7 vilmacrazy Win Xp 12 posts There is nothing to download from the HP website. I can scan a document using any (?) graphics software.. this content Drivers The driver \Driver\WUDFRd failed to load for the device errorHi i have a couple of weeks ago installed windows and i just got bsod crash and this was the only

Open the scanner lid. Hp Psc 1350 Troubleshooting Step two: Align the cartridges Follow these steps to align the cartridges. If the issue persists, continue to the next solution.

Open the scanner lid.

Only add paper to the tray when the product is not printing. Disconnect the product cord from any power strip or surge suppressor, and then plug it directly into a three-prong wall outlet. If the product uses a power module with a detachable power cord, disconnect the cord from the power module. Hp Psc 1210 Reset Close the cartridge access door by pressing firmly on the door until it snaps into place.

Figure : Snap the cartridge into place Close the cartridge access door. The sequence must be completed within 10 seconds. Blogs Recent Entries Best Entries Best Blogs Blog List Search Blogs Home Forums HCL Reviews Tutorials Articles Register Search Search Forums Advanced Search Search Tags Search LQ Wiki Search Tutorials/Articles Search http://batteryuniveristy.com/hp-psc/hp-psc-1350-problem.php Privacy Policy © Copyright 2016 HP Development Company, L.P.

If the product does not scan, follow the same steps and try a different wall outlet. note: An E might also appear in the Copies display. Click on Go menu (Click the desktop, then look at the menu in the bar at the top of the page)2. This video shows how to print a test page Click here to see this video in full screen on YouTube.

Reply 0 Re: Windows 10 08-06-2015 02:00 PM After installation a cumulative update of Windows 10 upgrade the driver for scanning and printing with HP psc 1350 all in one is Then slide the cartridge out of the carriage. Load plain, white paper into the paper tray. Follow these steps to clean the paper feed rollers.

Solution four: Service the All-in-One If you have completed all the steps and are still experiencing a problem, continue to the Service the All-in-One section at the end of this document. On some models, the language and country/region settings also reset. Solutions Solution one: Wait for the All-in-One to complete the job Allow the product to complete the job. Look inside the product to see where the carriage is stuck, and then check for any torn paper or objects that might be restricting the carriage.

Performance good. Wait 15 seconds. Videos English Open Menu English Deutsch Español Français Português 中文 한국어 † The opinions expressed above are the personal opinions of the authors, not of HP.

© Copyright 2017 batteryuniveristy.com. All rights reserved.