Home > Hp Psc > Hp 1310 Error

Hp 1310 Error

Contents

When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time. If these steps resolved the issue, you do not need to continue troubleshooting. Step four: Print a self-test report Follow these steps to print a self-test report. If these steps resolved the issue, you do not need to continue troubleshooting. his comment is here

If the computer message is NOT Print Cartridge Error (instead, it says that the cartridge you have removed is ...Either missing, not detected, or incorrectly installed), then the cartridge you have Reply 0 Reply 0 0 Everyone's Tags: LEGAL View All (1) Travis_C Regents Professor Posts: 4,871 Member Since: ‎11-22-2011 Message 2 of 7 (1,454 Views) Report Inappropriate Content Re: HP 1310 If the lights on the control panel still blink, continue to the next step. Check the lights on the control panel to make sure that they are no longer blinking. additional hints

Hp 1350 Printer Check Print Cartridge Error

If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. If these steps resolved the issue, you do not need to continue troubleshooting. If these steps resolved the issue, you do not need to continue troubleshooting.

  • Press and hold the Cancel button (), and then press the Start Copy Color button.
  • Figure : Load the alignment page Close the scanner lid, and then press the Scan button on the control panel.
  • If the product does not scan, follow the same steps and try a different wall outlet.
  • If the product does not complete the cartridge alignment, it will print an alignment page every time you turn it on.
  • Press the On/Resume button () to turn on the product.

A sequence of buttons on the control panel must now be pressed in the order presented. Unplug the power cord from the wall outlet. Solution four: Remove and reinstall the cartridges Follow these steps to make sure that both cartridges are installed and seated correctly. Hp Psc 1350 Manual note: Remove paper as carefully as possible.

Figure : Open the cartridge access door Carefully remove any jammed paper from the front of the product. Hp Psc 1210 Check Print Cartridge Error Look inside the product to see where the carriage is stuck, and then check for any torn paper or objects that might be restricting the carriage. With the product turned on, disconnect the power cord from the rear of the product. you could try here If these steps resolved the issue, you do not need to continue troubleshooting.

Step two: Test the power on the All-in-One Follow these steps to test the power on the product. How To Reset Hp Psc 1410 Printer Don't forgot to say thanks by giving "Kudos" to those that help solve your problems.When a solution is found please mark the post that solves your issue. Your reply is all well and good, but just explain how I Uninstal the computer?Robert Barrie Customer: replied6 years ago. How does HP install software and gather data?

Hp Psc 1210 Check Print Cartridge Error

A sequence of buttons on the control panel must now be pressed in the order presented. Press the On/Resume button () to turn off the product. Hp 1350 Printer Check Print Cartridge Error This video shows how to replace the ink cartridges Click here to see this video in full screen on YouTube. Hp Psc 1210 Troubleshooting I've had some help from you before.

Remove any loose paper Do not pull jammed paper Step two: Clear the paper jam from the rear of the All-in-One caution: Never pull jammed paper from the front of the this content Figure : Reinsert the cartridge Firmly push the cartridge in until it snaps into place. This video shows how to print a test page Click here to see this video in full screen on YouTube. Whether they are flashing, blinking, or compeltely off? Hp Psc 1315 Check Printer Cartridge Error

Please try the request again. When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time. While holding the Cancel button (), press and hold the On/Resume button (). weblink Solution five: Check for carriage obstructions Follow these steps to make sure that the carriage can move freely.

If these steps resolved the issue, you do not need to continue troubleshooting. Hp Psc 1350 Troubleshooting note: If the carriage does not move into the access area, turn the product off and then on again. Try the intended task again.

Solution three: Perform a partial reset A partial reset returns the user settings to their factory defaults.

Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, If these steps resolved the issue, you do not need to continue troubleshooting. When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time. Hp Psc 1210 Reset Figure : Open the cartridge access door Remove the black cartridge by pressing lightly on the top of the cartridge to release it from its slot.

The carriage moves to the center of the product. replied5 years ago. Figure : Disconnect the power cord Wait 15 seconds. check over here Solutions Solution one: Turn the All-in-One off and then on again Follow these steps to turn the product off and then on again.

Figure : Gently remove the jammed paper caution: Use a flashlight to thoroughly check the rollers and wheels for torn pieces of paper that might remain inside the product. On some models, the language and country/region settings also reset. If your printer is connected to the computer with a USB cable, disconnect the cable from the printer. I have a hub, and just removed my flash drive.PSC 1310 Series (1315xi), XP Home, SP3.

Figure : Remove the rear access door Gently remove any jammed paper or bits of torn paper from the rollers inside the product. HP Download and Install Assistant Follow the instructions below to install and run HP Download and Install Assistant using the HP Support Solutions Framework. It might take several tries to complete the sequence within ten seconds. This video shows how to print a test page Click here to see this video in full screen on YouTube.

If the product does not turn off, continue to the next solution. Figure : Disconnect the power cord Wait 15 seconds. Sowrav D. Unplug the printer.

If the carriage is stuck in the middle of the product, move the carriage to the right side of the product. Figure : Disconnect the power cord Wait 15 seconds. If you have a defective cartridge or printhead, it might be under warranty. Solution two: Cancel and then retry the task Follow these steps to cancel and then retry the current task.

If these steps resolved the issue, you do not need to continue troubleshooting. Apply a moderate amount of pressure to remove any dust or dirt buildup. Figure : Open the cartridge access door Without turning off the product, disconnect the power cord from the rear of the product. Z7_3054ICK0KGTE30AQO5O3KA3073 hp-detect-load-my-device-portlet Actions ${title} Loading...

Open the scanner lid. Securely connect the alternate USB cable to the computer.

© Copyright 2017 batteryuniveristy.com. All rights reserved.