Home > Hp Laserjet > Hp 3015 Error Codes

Hp 3015 Error Codes

Contents

HP Laser Jet 4000 13.5 PAPER JAM 13.6 PAPER JAM Paper delay jam at Fuser (13.05) or Paper stopped jam at Fuser (13.06). 13.10 PAPER JAM Paper delay jam at paper x = description 1--printer fan 1. Back Error 11 - Paper Out Paper tray empty or not seated correctly. ERROR 80 80X.YYYY ALL Printers The EIO card in slot X has encountered a critical error -power cycle, reseat card then replace card if needed. http://batteryuniveristy.com/hp-laserjet/hp-laserjet-3015-error-s.php

Caution needs to be used when installing the new assembly - be careful of the sensor flag spring! 5Si - Can be caused by field replaceable units (FRU's) not installed correctly. Rear-door assembly 1. On the 4/4M/4+ and 5: The print job is to complex, enable page protect from the control panel and from the software. Open the lower-rear door, and then release one tab. 6. http://h20564.www2.hp.com/portal/site/hpsc/public/psi/troubleshootResults?sp4ts.oid=378048

Hp Laserjet P3015 Printer Troubleshooting

Check the connectors on the DC controller and power supply. If it's broken, you will need to replace the sensor flag. Easily replaced after removing the top cover and three wiring harness connectors. Defective Internal Memory - Replace Formatter PCA, check all cables first!

  1. LJ 4250/4300/4350 A printer fan is not funtioning.
  2. X represents the fan motor number associated with the error.
  3. I was surprised to find out that several other people had complained of the same problem.
  4. Bad drive gears.
  5. Reset the maintenance count on HP LaserJet 4100MFP, 4101MFP, Laser 4200, 4300, 4250, 4350 and HP 9000, 9040 and 9050 1.
  6. This process can take several minutes depending on the number of warranties being checked.
  7. Error 79 Software/drivers, Memory PCA's, Font-Macro-Personality Cartridges, option I/O Cards.
  8. I decided after replacing the laser scanner assembly,  HP LaserJet Enterprise P3015 Series Laser/Scanner Assembly, LJ P3015/M525mfp RM1-6322-000 to do some research on the internet to see if others were having
  9. May need to reload your PostScript print driver file.
  10. Take a sharp tool, like a razor blade and scrape the buildup off these edges.

System error 05:09 (DJ 500 only) Formatter installed instead of HP-GL/2 accessory card. If you want to attempt board level repair try the electrolytic capacitor, C702, 10 uF 50 VDC. Washington (City of LA) 91321 Newhall (Santa Clarita) 91343 North Hills (City of LA) 91601 North Hollywood (City of LA) 91602 North Hollywood HP error codes 91603 North Hollywood LaserJEt error Hp Laserjet P3015 Error Printing Press the spring contacts and listen for the micro switches.

On the II and III Series printers, this error message can be caused by a faulty paper control PCA. Hp Laserjet P3015 Printer Manual System error 71:06 Out of memory problem. Notify me of new posts by email. Replace the Fan.

Verify that you can hear the motor rotate. 2. Hp P3015 Cold Reset Wait for RESET MAINTENANCE COUNT to be displayed and then release both keys. NOTE: Some versions of the 4000, 4050, 4100, and 5000 will NOT have their maintenance count reset Would you offer guest writers to write content to suit your needs? Change product Choose from all HP products Enter product serial number Please wait while we process your request.

Hp Laserjet P3015 Printer Manual

System error 11:11 The trailing cable is poorly connected System error 11:13 Problem with setting the voltage of the printheads System error 12:11 A short has been detected in the carriage Back back to top How did we do? Hp Laserjet P3015 Printer Troubleshooting Terms and Conditions | Privacy Policy | Site MapWebsite Design by Kick Interactive Laser Printer Repair and Fax, Copier Service ArticlesThis Website is Dedicated to Providing Free Service and Repair Articles Hp Laserjet P3015 Troubleshooting Paper Jam System error 04:11 Jet direct network card not detected.

Verify the tab on the cover is not broken. http://batteryuniveristy.com/hp-laserjet/hp-laserjet-3015-windows-xp.php How did we do? Occasionally the contact for the micro switch will get bent and will have to be replaced. On the LJ4/4M/4+/4M+ the sensor flag can get knocked out of place when a paper jam occurs and the tray is pulled out abruptly. Hp Laserjet P3015 Blinking Lights

If not replace the motor or drive circuit as required. Depending on the model, a firmware DIMM may need replacing or a flash update. Open the rear door. 2.  Gently pull down on the door and lower the door until it is fully open. 3. his comment is here Defective Tray Size Sensing or Configuration - Most trays have tabs which depress a series of switches when installed.

HP 500 System error 01:11 The electronics module has detected a connection problem with the cooling fan. Hp Laserjet P3015 Not Printing From Tray 2 Back back to top How did we do? Washington) 91343 Los Angeles (North Hills) 91601 Los Angeles (North Hollywood) 91602 Los Angeles 91603 Los Angeles 91604 Los Angeles 91607 Los Angeles 91324 Los Angeles (Northridge) 91325 Los Angeles 90272

Go to the MAINTCOUNT screen and press + or - to scroll the number to zero (all zeros). 3.

Note: this message will only appear in the Configuration Menu if the PERFORM USER MAINTENANCE message appears. I am new to this and do not want to screw this up. I have joined your rss feed and look forward to looking for extra of your magnificent post. Hp Laserjet Service Request Raised Check the I/O connections and make sure the proper media is being used.

Lift the cover away from the product. You can try reducing the DPI or unticking the collate option in the printer driver. If I use it enough I will definitely donate.Thanks again. weblink On the IIP/IIIP this can be caused by a defective toner cartridge, defective cooling fan, PS4 or PS5 sensors.

On the 4V/4MV check the toner cartridge micro switch on the High Voltage PCB - SW501. Left cover 1. Lift the laser/scanner up and out of the product.HP LaserJet Enterprise P3015 Series Laser/Scanner Assembly, LJ P3015/M525mfp RM1-6322-000Conclusion about the 51.10 error  in the HP laserjet  P3015 PrinterHopefully the 51.10 error On the 5L, set the Enhanced I/O to AUTO (PCL mode) and resend the print job.

If the problem continues, remove the optional interface card and set the printer for standard parallel interface by taking off-line and holding down "Menu" key for 5-10 seconds. Some error codes are self explanatory and are not included. Each model printer will have a slightly different wording for the error, but the trouble shooting tips are generally the same. If the display panel on your HP LaserJet printer reads "PERFORM PRINTER MAINTENANCE" your HP LaserJet printer needs a maintenance kit, which includes a fuser unit and separation rollers.

System error 41:10 A problem has been detected with the Paper-Axis motor System error 41:13 An error in the paper-axis motor encoder quadrature has occurred. You can depress these by hand and hear them click. What to do:First of all try resetting the printer by turning it on and off. Simplify the print job by removing font changes and/or graphics.

Z7_3054ICK0KGTE30AQO5O3KA3072 hp-country-locator-portlet Actions ${title} Loading... Complementary Content PrinterTechs.com 608-831-2396 or 866-352-7108 About Us Contact Us Search Products Search Support All Products PrintersHewlett PackardLexmarkCables and Misc.JetDirect CardsBrotherKyoceraDell Toner Maintenance Kits Printers Parts Tech Support Account Login Shopping Check I/O Cable, it could be the wrong cable or damaged. and may not be used without advance written permission of PrinterTechs.com, Inc.

This pad needs to provide friction to the feeding paper.

© Copyright 2017 batteryuniveristy.com. All rights reserved.