Home > Hp Deskjet > Hp Deskjet 5550 Mechanism Error

Hp Deskjet 5550 Mechanism Error

Contents

Ask Loading...Oops :Please try again. After seeing this thread I decided to try to manually move the carriage to see if it could then re-set itself...Not sure if manually moving the carriage is recommended, but it Close the cartridge door. pl. his comment is here

Solution No action is required. While holding the Power button, press the Resume button () four times. Privacy Policy Terms of Use Sign Up Login Add Question Stephen asked Feb 9, 2006 at 7:59am 2 Unknown Printer DeskJet 5550 Resume light flashing, Power too, etc I had 5 by Stephen on Dec 11, 2006 at 5:59pm Add comment Please sign in to comment 0 I've seen this problem a couple of times, in each case it turned out to find this

Hp Deskjet 5550 Blinking Ink Light

Also, clean the large rubber rollers with a cloth dampened with water. NOTE: Do not pull on the ribbon cable when moving the carriage. 6. Use both hands to pull whole sheets of paper to avoid tearing them. If the issue persists, continue to the next solution.

  1. Gently push the door forward until it snaps into place.
  2. Solution four: Remove and reinstall the cartridges Improper placement or incorrect installation of the cartridges might cause the carriage stall error.
  3. Go to this web page to decode any blinking lights.http://h10025.www1.hp.com by Bert on May 10, 2005 at 9:36am Add comment Please sign in to comment Dear Bert.
  4. Choose from the following two methods to clear the paper jam through the rear access door or the duplexer.

Remove the new cartridge from its package, and then carefully remove the protective tape. Country: United States Select a location Americas Europe, Middle East, Africa Asia Pacific and Oceania Select a language Confirm Back Z7_M0I02JG0KOT530A6KJKFRQ0816 hp-detect-load-my-device-portlet Actions ${title} Loading... Try to print a self-test report. Hp Deskjet 5550 Not Printing Follow the on-screen instructions to order new cartridges or check cartridge compatibility with your printer.

If the product does not turn on by itself, press the Power button () to turn it on. Hp Deskjet 5550 Troubleshooting Reattach the rear access door. Reattach the rear access door. http://h20564.www2.hp.com/hpsc/doc/public/display?docId=c00035263 Remove the rear access door.

Check for obstructions inside the tray. How To Free Cartridge Cradle On Hp Printer Figure : Remove the rear access door Lightly dampen a clean, lint-free cloth with bottled or distilled water, and then squeeze any excess liquid from the cloth. The product might be out of paper. If you have to rethread the strip, or reposition the spring mount flanges it's a lot easier if you take the cover off first, instructions somewhere in this thread.

Hp Deskjet 5550 Troubleshooting

Country: United States Select a location Americas Europe, Middle East, Africa Asia Pacific and Oceania Select a language Confirm Back Z7_M0I02JG0KOT530A6KJKFRQ0816 hp-detect-load-my-device-portlet Actions ${title} Loading... http://www.fixya.com/search/p378818-hp_deskjet_5550_inkjet_printer/mechanism_error_print_cartridge_cradle_cannot_move This has been broken (the two feet which hold it to the printer) and it was lodged just behind the 'sled' disabling it from traveling to the right fully.I have removed Hp Deskjet 5550 Blinking Ink Light Figure : Clean the paper pick roller Allow the rollers to dry for 10 to 15 minutes. Cartridge Cradle Cannot Move Solution Hp If the issue persists, continue with the next solution.

Wait for the carriage to move. this content Figure : Paper pick roller Lightly dampen a cotton swab moistened with bottled or distilled water, and then squeeze any excess liquid from the swab. If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. Cleaning it with a wet tissue (from the non spring end only) made it transparent again and my printer WORKS AGAIN!!!This has saved me £111 over sending it back to those Hp 5550 Print Cartridge Status Light Is Flashing

Press the Power button () to turn on the product. Turn the printer off, free the cartridge cradle, and turn the printer back on." But when I look at the cartridge cradle it seems to be ... Slide the cartridge at a slight upward angle into the empty slot, and then gently push it forward until it snaps into place. http://batteryuniveristy.com/hp-deskjet/hp-deskjet-5550-error.php Insert the duplexer into the rear of the product, and then push it forward until it snaps into place.

Figure 3: Check the power connection 1 - The power adapter cord connection 2 - The power cord connection 3 - The wall outlet If these steps resolved the issue, you Hp Printer Cartridge Stuck Right Side Reconnect the power cord to the back of the product. Step one: Reset the printer Press the Power button () to turn on the product.

Step one: Check the condition of the paper Remove the stack of paper from the tray.

Click the tab that provides paper type and size settings. So to reset remove your printer from the PC and uninstall the printer software. Disconnect the USB cable from the back of the product. The Print Carriage Cannot Move Hp Envy 4500 Issue: The Power light and the Print Cartridge light are on In this error condition, the following light pattern displays on the product control panel and a message might display on

If the carriage is stuck on the left side of the product, move the carriage to the right side of the product. ERROR 49.4018 appears quite often.As of right now... Privacy Policy © Copyright 2016 HP Development Company, L.P. http://batteryuniveristy.com/hp-deskjet/hp-deskjet-5550-error-printing.php Visit now Z7_3054ICK0KGTE30AQO5O3KA30H4 hp-feedback-banner-portlet Actions ${title} Loading...

Slide the cartridge at a slight upward angle into the empty slot, and then gently push it forward until it snaps into place. With the product turned on, disconnect the power cord from the rear of the product. If the issue persists, continue with the next solution. Disconnect the USB cable from the back of the product.

If this roller is not clean, more paper feed issues are likely to occur. Take out the output tray so you can see better, and a flashlight might help.Keep the printer level while testing, tilting a 5550 can lead to spilling ink from the service Figure 47: Clean the paper pick roller Allow the rollers to dry for 10 to 15 minutes. Reconnect the power cord to the rear of the product.

Step two: Print a self-test report Print a self-test report to make sure that the hardware functions correctly. Solution five: Service the printer If you have completed all the solutions listed above and are still experiencing a problem, continue to the Service the printer section at the end of Thanks - Anonymous 0 5550 Cartridge Latch Replacement ProcedureStart with power on.Open the top cover so the carriage moves to the center, then pull the power plug.Remove any installed cartridge(s).Note the Press the latch down until it snaps firmly into place.

Follow the on-screen instructions to order new cartridges or check cartridge compatibility with your printer. Raise the cartridge latch. Issue: All lights are off The following light pattern displays on the control panel: Print Cartridge status light: Off Resume light: Off Power light: Off Figure 2: All lights are off Issue: The Power light and the Resume light are on In this error condition, the following light pattern displays on the product control panel: Print Cartridge status light: Off Resume light:

If the issue persists, continue to the next solution. Press and hold the Power button (). Please advise..Its Xtremely URGENT! Figure : Access door Open the cartridge door.

Figure : Clean the paper pick roller Allow the rollers to dry for 10 to 15 minutes. Figure : Move the paper guides outward Insert a stack of plain white paper into the input tray.

© Copyright 2017 batteryuniveristy.com. All rights reserved.