Please try the request again. Unplug the power cord from the wall outlet. I unplugged the printer for two days; no change. tecnical support for hp printing Reply 1 1 LiveAboardDave Intern Posts: 30 Member Since: 04-07-2011 Message 5 of 5 (3,564 Views) Report Inappropriate Content Re: deskjet 5550: resume & power lights http://batteryuniveristy.com/hp-deskjet/hp-deskjet-5550-error.php
Reach inside the product, and then manually move the carriage. Press the Power button () to turn on the product. Solution Follow these steps to replace the black cartridge. Wait 15 seconds. Read More Here
Reach inside the product, and then manually move the carriage. This was not mechanical as I could easily print from the laptop. My DeskJet 5550 was working fine with this computer and then my wife made out a birthday card using heavy stock and something happened to cause a carriage jam. When I turn on the HP5550 it quietly jerks the cartridge back & forth a hair a couple of times & then the lights start blinking again.
If that is the problem then as above just tape down the lever. That worked one last time. by Stephen on Sep 21, 2005 at 5:08pm Add comment Please sign in to comment 0 When you say it jams are you getting a flashing light, or lights? Hp Deskjet 5550 Troubleshooting Guide Disconnect the USB cable from the rear of the product.
Has this ever happened to anyone before??? Hp Deskjet 5550 Manual I waited a few minutes, removed the magenta cartridge and left the lid open and waited for about 3 minutes. Remove the duplexer. Figure 44: Remove the rear access door Lightly dampen a clean, lint-free cloth with bottled or distilled water, and then squeeze any excess liquid from the cloth.
Generated Thu, 24 Nov 2016 14:24:18 GMT by s_hp90 (squid/3.5.20) Hp Deskjet 5550 Reset Reconnect the power cord to the rear of the product. If the issue persists, continue with the next solution. I noticed how frail and thin the plastic with contacts are at the back of the cartridge receptacle in the printer.
I've cleaned the spray area using alcohol and even a quick runthrough of warm water under a running faucet. you could try here While holding the Power button, press the Resume button () four times. Hp Deskjet 5550 Blinking Ink Light Figure 77: Insert the cartridge Close the cartridge latch. Hp Deskjet 5550 Printer Driver CAUTION: Do not remove jammed paper at this stage.
I checked all connections, unpluged the printer for about 90 seconds, then when that did not work, turned my computer off for about 90 seconds, still nothing. http://batteryuniveristy.com/hp-deskjet/hp-deskjet-5550-error-printing.php works fine from my older pc, but the new pc just spits out a blank sheet of paper. I need the little black-spring loaded- part under the cartridge door (blue door #57) which holds the cartridge tight to the contacts. If the issue persists, continue with the next solution. Hp 5550 Print Cartridge Status Light Is Flashing
Issue: The Power light blinks In this normal condition, the following light pattern displays on the product control panel: Print Cartridge status light: Off Resume light: Off Power light: Blinking Figure Follow the on-screen instructions to order new cartridges or check cartridge compatibility with your printer. by mahbuban on Dec 17, 2007 at 11:28am Add comment Please sign in to comment 0 The plastic part that usually breaks on the 5550s is a part of the pusher http://batteryuniveristy.com/hp-deskjet/hp-deskjet-5550-mechanism-error.php I have tried it with & w/o cartridges installed.
Wait at least 15 seconds. Hp Deskjet 5550 All Lights Blinking If the issue persists, continue to the next solution. If the issue persists, continue with the next solution.
Unplug the power cord from the wall outlet. Then I turned the machine off and un-stuck my cartridges so they were all the way to the left again. Look for the gray-colored carriage on the right side of the printer. (Note: my carriage is is stuck in the center). 4. Hp 5550 Deskjet Printer Troubleshooting Figure 99: Remove the cartridge Step two: Insert a new cartridge Follow these steps to insert a new cartridge.
Nothing from the thread looked relitive until i read about the cleaning station.There is a fitting (flat grey plastic) which holds the ribbon to the back of the printer. Figure 60: Reattach the duplexer Press the button on top of the duplexer, and then open the duplexer door. Press the Resume button () to continue printing. check over here Apply a moderate amount of pressure to remove any dust or dirt buildup.
If one or both of the cartridges are missing, continue to the next step. If the product does not turn on by itself, press the Power button () to turn it on. How to print a self-test report Make sure that plain white paper is loaded in the input tray. Solution three: Replace the cartridge Follow these steps to replace the tri-color cartridge.
While holding the Power button, press the Resume button () four times. It'd be a shame for the printer to suffer from an unfortunate accident.... Many newer HP printers use the same catridge set. Insert the duplexer into the rear of the product, and then push it forward until it snaps into place.
Use both hands to pull whole sheets of paper to avoid tearing them. While holding the Power button, press the Resume button () four times. Method one: Clear the paper jam through the rear access door Press the Power button () to turn off the product. Gently remove the plastic cover that is over the spot sesor.
note: Do not press the buttons on the sides of the duplexer when reattaching it to the product or it might not snap securely into place. It says that it is a test page, and under status it says, "deleting." Any ideas what the problem could be? Solution one: Wait for the print job to complete Wait for the product to finish processing the print job. by Stephen on Sep 7, 2005 at 8:15pm Add comment Please sign in to comment 0 Yes, I admit I pulled the paper out of the front and the darn resume
Choose from the following two methods to clear the paper jam through the rear access door or the duplexer.