Digital lines are OK to use, but there is a greater chance that your fax machine will encounter communication issues. Resend the document as a normal fax, rather than attempting a BFT transfer. 320 The local machine is set to initiate poll reception with a remote machine, but detected that the They set up another and it works perfect! If ECM is enabled, then disable it. http://batteryuniveristy.com/fax-error/hp-4500-fax-error-346.php
Retry the fax reception when line conditions might have improved. The click, heard for an incoming call, is actually a momentary disconnect of the line. The remote machine temporarily disabled answering due to a condition such as lack of paper or a paper jam. These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line).
However, if you get these error codes frequently when faxing with your HP Officejet there is likely a communication issue occuring with your fax line. Right-click on cmd.exe and choose Run As Administrator. HP Officejet Pro L7555 and L7590 All-in-Ones - Interpreting Error Codes in Fax Communication Error or Fax History Reports Introduction The following error codes may appear on a fax communication error Hp Fax Error 388 Call the telephone provider if line conditions fail to improve 384 The local machine attempted a black JPEG transmission to a machine that does not support this mode.
How does HP install software and gather data? Try the fax when telephone line conditions have improved. 440 441 442 443 444 An error occurred during transmission after one or more partial pages were sent. Then the problem is most definately on the ... http://h30434.www3.hp.com/t5/LaserJet-Printing/HP-Officejet-Pro-8500-A910-error-344/td-p/614251 Question about HP Printers & Copiers 1 Answer Error code 344* Error code 344* Everytime I try to send a fax the system dials, connects to other fax, faxes one page
An error code can have more than one definition (cause), and more than one solution. Ecm Setting On Fax The paper is not correctly loaded and the document sensor cannot sense it. Symptom of error:Error message pops up "hp officejet 4500 fax error 344" System Performance becomes slow/sluggish. This is usually a defect in the remote sending machine. *If ECM is enabled, then disable it.
The noise problem might go away over time. this content If these transmissions are successful, then notify the user of the remote machine to make them aware of the issue. This might occur naturally depending on when the fax session is terminated. Try to send the fax using a different mode. Hp Fax Comm Error
This error is very rare because normally a remote machine will not answer if it cannot receive a document. Symptom of error:Error message pops up "hp officejet 4500 fax error 344 480p" System Performance becomes slow/sluggish. Select a slower reception speed. weblink Retry the fax reception when telephone line conditions have improved.
This error does not result in the session being terminated immediately. Error Code 345 When I Try To Fax Disable ECM. Reduce or enlarge the page size setting on the local machine to a size supported by the remote machine. 319 The local machine attempted to initiate a binary file transfer (BFT),
After 10 seconds, turn it back on. Faxing is old analog technology. Both machines have attempted to start a reception at the same time. Hp Fax Error 350 The click, heard for an incoming call, is actually a momentary disconnect of the line.*The remote user pressed the Stop key while the reception was in progress.*Under rare conditions, incompatibility between
Call the telephone provider if line conditions fail to improve. Subsequent page transmission can still occur and later pages may be received without error. *Re-attempt the fax transmission at a time when telephone line conditions have improved. Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, http://batteryuniveristy.com/fax-error/hp-officejet-4500-fax-error-351.php Reply 0 0 FlaReitree Honor Student Posts: 1 Member Since: 03-10-2013 Message 6 of 8 (21,800 Views) Report Inappropriate Content Re: HP Officejet Pro 8500 A910 error 344 Options Mark as
Interpreting fax transmit error codes Error code Error definition and solution 300 The fax session has completed without errors. 311 Pressing the Stop button caused the session to be prematurely halted In some cases this error can occur if the other fax machine is using a fax format incompatible with the HP fax. 422 423 A handshaking (connection) error occurred at some Try sending at a lower transmission speed. Please try the request again.
Virus or malware infection. Configure the remote machine for document reception by clearing any paper jams, loading sufficient paper, and clearing any other error messages.